--- title: "ColorCorrection" canonical: "https://documentation.chaos.com/space/LAV/124522447/ColorCorrection" format: markdown --- This page provides information about the ColorCorrection texture in Chaos Vantage. Overview The ColorCorrection texture enables the application of various color corrections to a texture, including adjustment of brightness, contrast, hue, saturation, and options for rewiring the RGB channels. Settings Source color – Specifies the input color or texture to be corrected. Rewire red / green / blue / alpha – Allows the following channels to be assigned into the Red, Green, Blue or Alpha channels: Red – Assigns the red channel. Green – Assigns the green channel. Blue – Assigns the blue channel. Alpha – Assigns the alpha channel. Redinv – Assigns the inverse of the red channel. Greeninv – Assigns the inverse of the green channel. Blueinv – Assigns the inverse of the blue channel Alphainv – Assigns the inverse of the alpha channel. Monochrome – Assigns the channel to be monochrome. One – Assigns the value 1. Zero – Assigns the value 0. Hue shift – Specifies a value for the adjustment of the current color hue. Saturation – Specifies a value for the saturation or desaturation of colors. Hue tint – Specifies a color that is used to tint current colors. Tint strength – Adjusts the strength of the hue tint. Lightness mode – Specifies the lightness mode that is used. You can choose between Standard and Advance mode. Exposure mode – Specifies the exposure method. Gain – In this mode, the Brightness value is a simple multiplier for the input colors. F-Stops – In this mode, the Brightness value multiplies the color intensity with photographic F-stop exposure. Increasing the Brightness by one doubles the brightness, the same as increasing the Gain by 2. For example, this mode's input value of 1.0 and Brightness of 0.0 equals 1.0 (i.e., no brightness correction). Then, Brightness 1.0 corrects the input of 1.0 to equal 2, Brightness 2.0 corrects the input of 1.0 to equal 4.0, Brightness 3.0 corrects the input of 1.0 to equal 8.0 and so on. The input is multiplied by 2 to the power of the brightness value in this mode ( * 2 ^ ). Printer Lights – When set with the same value as the Printer Lights Per Stop parameter is set, it doubles the luminance. Brightness – Adjusts the correction of color brightness. Gamma / Contrast – Controls the gamma and contrast. Increasing gamma, decreases the contrast. Contrast – Adjusts the correction of color contrast. Base – Adjusts the correction of contrast base. Offset – Adjusts the correction of color offset. Use Red / Use Green – When enabled, uses the corresponding component for the advanced RGB parameters.